Baby BMW Forum banner

Replacing front wheel bearing

6K views 7 replies 8 participants last post by  Badley 
#1 ·
#3 ·
They are quite expensive from BMW!

Thanks for posting the guide :)
 
#5 ·
Maybe the threadlock compound will let go if heated? A couple of minutes with a blow torch around the areas where the bolt ends are visible could help.

Spraying the relevant areas with a penetrating oil is also a good tip for this kind of work. And you should leave it for at least ten-fifteen minutes to let it work its way into the rusty htreads.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top