How To: Retrofit Puddle Lights

This section shows how to carry out modifications to your 1 Series. Please remember that if you are modifying your car to take photo's at each step and document the mod in here.
Please read the announcement at the top of the section before posting.

Moderators: marco_polo, babybmwadmin, Lambster, Rich196, Producethis

topcat5446
Junior Member
Junior Member
Posts: 1
Joined: Wed Dec 26, 2012 4:17 am

Re: How To: Retrofit Puddle Lights

Post by topcat5446 »

smithy120d

can you please tell me where you got your diy LEDs for your puddle light upgrade
User avatar
Tommy_town
Junior Member
Junior Member
Posts: 42
Joined: Mon Dec 02, 2013 6:03 pm

Re: How To: Retrofit Puddle Lights

Post by Tommy_town »

When re fitting the weather seal , do you need to apply some new sealant / glue?


Sent from my iPhone using Tapatalk
Smithy120d
Experienced Member
Experienced Member
Posts: 255
Joined: Sat Apr 11, 2009 11:55 am
Location: Tyne & Wear. UK

Re: How To: Retrofit Puddle Lights

Post by Smithy120d »

Tommy_town wrote:When re fitting the weather seal , do you need to apply some new sealant / glue?


Sent from my iPhone using Tapatalk

No. The glue should still be sticky enough. I cut through the sealant with a stanley knife, and the two amalgamated when they were pressed together.
Sydney Blue '55 120d Sport
DIY Modifications: Footwell & Puddle lights, EC rear view mirror, Heated seats, & a few bits of coding.
User avatar
Joe
Enthusiastic Member
Enthusiastic Member
Posts: 1857
Joined: Sun Apr 20, 2014 3:03 pm
Location: Swindon

Re: How To: Retrofit Puddle Lights

Post by Joe »

I need to replace my drivers front light, how do I go about removing the housing with a key lock in it?
2010 118i ///M Sport
Smithy120d
Experienced Member
Experienced Member
Posts: 255
Joined: Sat Apr 11, 2009 11:55 am
Location: Tyne & Wear. UK

Re: How To: Retrofit Puddle Lights

Post by Smithy120d »

Joe wrote:I need to replace my drivers front light, how do I go about removing the housing with a key lock in it?
Remove the rubber bung on the rear of the door and unscrew the allen bolt holding the handle to the door.
Sydney Blue '55 120d Sport
DIY Modifications: Footwell & Puddle lights, EC rear view mirror, Heated seats, & a few bits of coding.
User avatar
Joe
Enthusiastic Member
Enthusiastic Member
Posts: 1857
Joined: Sun Apr 20, 2014 3:03 pm
Location: Swindon

Re: How To: Retrofit Puddle Lights

Post by Joe »

Smithy120d wrote:
Joe wrote:I need to replace my drivers front light, how do I go about removing the housing with a key lock in it?
Remove the rubber bung on the rear of the door and unscrew the allen bolt holding the handle to the door.
Thanks for the reply. Sounds simple, I was expecting to have to unhook locks and all sorts!
2010 118i ///M Sport
User avatar
Joe
Enthusiastic Member
Enthusiastic Member
Posts: 1857
Joined: Sun Apr 20, 2014 3:03 pm
Location: Swindon

Re: How To: Retrofit Puddle Lights

Post by Joe »

All done today. Had a bit of a struggle getting the lock back in but now I've done I know how if required again.

LEDs are a slightly different colour which is annoying but better than no light at all.
2010 118i ///M Sport
roberdlv
Experienced Member
Experienced Member
Posts: 256
Joined: Thu Feb 26, 2015 2:04 pm

Re: How To: Retrofit Puddle Lights

Post by roberdlv »

Very good post, someone could help me make the original installation in the bmw f21? I have everything I need, I'm missing the original connections do not know where they go, also want to put ambient light inside handle and salvacharcos light in the bottom of the door, all in bmw f21, but no schemes of original installation, but if you I have the pieces
Delarioo
Knowledgeable Member
Knowledgeable Member
Posts: 51
Joined: Tue Jul 12, 2016 11:42 am

Re: How To: Retrofit Puddle Lights

Post by Delarioo »

Any advice for the door glue? Don't think mine will stick back on.. what cold I replace it with?

Issue with my car was two had puddle lights two didn't... one front one back.. the ocd can't handle it :lol:
E92 335i Autovogue black - Current
Smithy120d
Experienced Member
Experienced Member
Posts: 255
Joined: Sat Apr 11, 2009 11:55 am
Location: Tyne & Wear. UK

Re: How To: Retrofit Puddle Lights

Post by Smithy120d »

Delarioo wrote:Any advice for the door glue? Don't think mine will stick back on.. what cold I replace it with?

Issue with my car was two had puddle lights two didn't... one front one back.. the ocd can't handle it :lol:
Black Roof & Gutter sealant

Image
Sydney Blue '55 120d Sport
DIY Modifications: Footwell & Puddle lights, EC rear view mirror, Heated seats, & a few bits of coding.
Delarioo
Knowledgeable Member
Knowledgeable Member
Posts: 51
Joined: Tue Jul 12, 2016 11:42 am

Re: How To: Retrofit Puddle Lights

Post by Delarioo »

Thanks,

I have two of my doors prewired for this, two arent for strange reason.

Anyone know the adapter part? That i need to plug that handle into it guessing will need to purchase them
E92 335i Autovogue black - Current
Bully3176
Junior Member
Junior Member
Posts: 1
Joined: Wed Jan 17, 2018 6:12 pm

Re: How To: Retrofit Puddle Lights

Post by Bully3176 »

Hi All
Is anyone able to offer any assistance in retro fitting these into an F20? Does anyone know if the wiring is pretty much the same?? Any help and guidance would be greatly appreciated 👍
Hélder
Junior Member
Junior Member
Posts: 1
Joined: Sun Sep 02, 2018 10:39 am

Re: How To: Retrofit Puddle Lights

Post by Hélder »

Good morning, I'm from Portugal.
Can someone tell me a site where I can buy the 4 lights?
I have a BMW E90 318d 2008.
Thanks a lot for the help.
CA_130
Junior Member
Junior Member
Posts: 2
Joined: Tue Sep 18, 2018 10:22 am

Re: How To: Retrofit Puddle Lights

Post by CA_130 »

Hi All,

I know this thread is quite old, but is there a possibility to add or find the pics somehow? I recently got the puddle lights, but tinypic no longer exists. Any advice ?

Regards
Post Reply

Return to “How To's”