4 bulb errors but no faulty bulbs?

[0l0dom0l0]

Got in the car after it's been sat for a couple of days today and was greeted with an Xmas tree dash showing 4 bulb warning errors as seen in the photo.

Checked and all bulbs are fine and working.

The indicators are flashing fast as if there is a fault. (But all are working)

I have scanned for faults with Carly to no avail, other than the 4 fault codes for the faulty bulbs and 2 codes for driver and passenger hall sensor which I can never seem to clear.

Have loaded a backup onto the FRM from a few weeks ago using Carly. Nothing has changed since then and nothing was changed back then either. No change in warning lights.

FRM can be read and coded with no issue.

Will be checking the PDC for water later.

Anyone got any ideas?

Sent from my SM-G930F using Tapatalk

[Nottsknots]

Might be worth taking the FRM out and checking the connectors for corrosion. Three of those relate to pins on connector X14261, and are physically close together (pins 45, 50, and 51). Especially on an 11 year old car, unless its been stored in Jay Leno's garage.

[0l0dom0l0]

Might be worth taking the FRM out and checking the connectors for corrosion. Three of those relate to pins on connector X14261, and are physically close together (pins 45, 50, and 51). Especially on an 11 year old car, unless its been stored in Jay Leno's garage.

Ok thanks.

Will have to have a look another eve, too cold tonight.

FRM is in drivers footwell, that correct?

Did manage to get out and disconnect the battery for a few mins but 're connected and faults still appearing.

Is it likely to be anything to do with PDC? PDC works no issues.

I am suspecting an FRM issue. Thought it might be bricked but doesn't seem to be.

[0l0dom0l0]

BW chiptune
Tuning BMWs since 1991
Dyno Dynamics rolling road
BW autorepairs
Over 30 year repairing BMWs
New and fully refurbished BMW,Alpina Ecus and Cas units
BMW Keys made and cut same day
Correction of Engine ECUs Cas and key fitted to your car (when a key set from a different car has been used)
Digital Service Records rest and corrections in idrive screen on 2013 onwards cars
DPF repairs fixed without the need of removal of its guts or replacement
40% of my work is repairing the problems that are caused by other tuners Remaps

0208 561 1818
07831 103030
Hayes
UB3 1BB

Jason, Can you help?

[Octavius]

Could be a bad earth causing the errors.

[0l0dom0l0]

Will check that too.

Been reading into FRM failures. They are sounding similar to my symptoms.

I'm wondering if not coding my heated seats yet might have bit me in the ass so the first thing I'm going to do is code them and do a code to default on the FRM after I've added the heated seat option to the VO and see where we are then.

[KoenigKT6]

Thread bump.....

Did you get to the bottom of the fast flighting indicators and check errors?
Mine has started to do that same today. All bulbs work.

[Dcds4]

Same boat here, any info would be great

[0l0dom0l0]

I've had messages from both of you and been no help at all so I've had a read through the thread.

I must have coded the heated seats after this which would have essentially meant doing the coding for the heated seats and coding the car back to standard, then 're applying my coding in Carly afterwards.

If you are clued up you could try coding a blank file to the FRM. Someone more clued up the coding would be able to help

Sent from my SM-G930F using Tapatalk

[Dcds4]

Some developments, I disconnected and charged the battery overnight, reconnected today and everything is back to normal, seems a bit odd as the battery shouldn't have been low, I only fitted and registered it 3 months ago. Not complaining!

[povsul]

Hi, I get the same 4 error message. Maybe someone find a solution?